Fits: 2011-2019 GM 6.6L Duramax LML/LGHPurchase this CTA Tools GM Fuel Line Disconnect Tool to work on your vehicle. CTA Tools has a wide selection of automotive specialty tools that make vehicle repairs and maintenance a breeze. Having the right tools is critical to any proper repair. Each componen..
Fits: 1994-1999 Dodge Cummins 2500/3500 (With 30-Spline Axles)
This kit eliminates the vacuum disconnect and replaces the two piece axle with a one piece 4340 chromoly axle. This kit includes the long side axle, disconnect block off kit and special axle seal.
Fits Dana 60 front differential
3..
Yukon Gear & Axle offers an extensive line of general replacement and high-performance axles for passenger car, truck and SUV applications. High quality alloys and the latest in heat-treating technologies provide a stronger-than-stock axle for off-road, on the street, or at the track.Fits Dana S..
Designed to Separate Quick-Connect Fittings on 3/4" Heater Lines on GM Vehicles.Hinged design allows the tool to slip over the heater hose, even in tight spaces. Slide the tool into the connector to release the line. Aluminum provides strength and durability. Heater hose disconnect demonstration/ in..
Set includes six sizes: 5/16", 3/8", 1/2", 5/8", 3/4" and 7/8".This set includes both sizes needed to service the quick connect fittings found on a Duramax enginePart number: 37000..
94-00 Dodge Dana 60 Front CAD Disconnect Fork
If you have a 2000 truck please verify that your truck needs the SMALLER style fork.
Spicer Part number: 42585
Image for representation only...
85-99 Dodge Dana 44/60 Front CAD Disconnect Collar
CAD (central axle disconnect) disconnect collar that connects the axle shafts on the passenger side.
Spicer Part number: 46401
Image for representation only...
Fits 1999 and up Dana Spicer 60 Dodge dicsonnect front
Included are Timken bearings and races along with high quality seals and small parts. Included in this kit are carrier bearings and races, pinion bearings and races, pinion seal, axle seals, complete shim kit, ring gear bolts, pinion nut, crush..
These hoses connect the standpipes to the high pressure oil rails, and ONLY fit engines with the early style round high pressure oil rails (ICP sensor at rear of engine under turbo). If your already replacing other parts of the high pressure oil system (ie: Stand Pipes or HPOP), it highly recommende..