Shop By Category
Your Cart

271/273 Transfer Case to Transmission Mounting Stud

QU11019 Dodge NV271D, NV273D Transfer Case Mounting Stud is a genuine original equipment New Venture Threaded Stud that is identical to the parts used in production NV271D and NV273D transfer cases. Six of these corrosion resistant Studs thread into the tapped holes in your New Process/New Venture NV271D Manual Shift or NV273D Electric shift front case half. Six Studs are used to bolt your transfer case to your transmission rear housing. Overall length of QU11019 is 2-7/64"+/-.  10mm Coarse Thread thread length (goes into case) is 13/16"+/-. 3/8" Fine Thread thread length (for nut) is 1"+/-. Sold individually. 

Need More Info? Use the handy Links below to access over 40 years of Dan's product and vehicle specific Tech Notes to easily get the information you need for your vehicle's repair, maintenance, or upgrade project!

Dan the Gear Man® Tech Notes:
Prep and Installation
Matching Parts

Tech Note 1: Prep and Installation
Apply S9978 or S2400 Threadlocker to the coarse threads before installing the Studs into the transfer case. Use either a Stud Install Tool or install and jam double nuts on fine thread end. Install Stud until approximately 1-1/4" combined length of shoulder and thread protrudes from front of case. Do NOT install Stud too deep by screwing it in until shoulder jams into case threads!

Tech Note 2: Matching Parts
QU11014 NV271D Front Case Half
QU50657 NV273D Front Case Half
QU10535 Special Transfer Case to Transmission Nut with Attached Rotating Washer
S9978 or S24200 Blue Threadlocker
Dodge & Ram Shop Manuals

Tech Note 3: NPG-NVG-MPT
When Ford (1999 models) and Dodge (2003 models) first used NV271 and NV273 transfer cases, New Process Gear (NPG) of East Syracuse N.Y was part of New Venture Gear (NVG). When NVG dissolved, NPG continued on under Chrysler. Chrysler subsequently sold the production rights to Magna, a Canadian automotive parts company. All these name changes are confusing, but the important thing to know is a specific assembly number for any 271F, 271D, 273D, and 273F transfer case is the same and uses the same replacement parts regardless of it was built by New Venture, New Process, or Magna.

NV271D and NV273D in Ram 2500, Ram 3500, Ram 4500, Ram 5500: 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012

QU11019 Transfer Case to Transmission Mounting Stud for Ram

Lame California Prop 65 Notice