07.5-18 Dodge 6.7L Cummins Glacier Diesel Mega-Flo S-3 Intake Manifold

Discontinued (Updated 2/29/2024)

Mega-Flo S-3 Cummins 6.7L Intake Manifold

Fits 2007.5-2013 Dodge 6.7L Cummins Diesels. 
Fits pickups & cab & chassis trucks.

Looking for massive airflow increases for your high performance 6.7L Cummins? The new GDP Mega-Flo S-3 intake manifold delivers!

The Mega-Flo S-3 is a precision, permanent mold, aluminum casting. Casting via permanent mold and then heat treating gives the Mega-Flo S-3 superior material density. The permanent mold process also offer a great finish for colored powdercoat finishes.

To maximize internal flow area, the #1 injector line relief is cast in as a solid boss. This allows us to finish machine the relief slot for tight tolerance and low interior protrusion. During final machining, all interior bosses are reduced to the absolute minimum needed for injector line clearance. From a design standpoint the Mega-Flo S-3 intake manifold is a perfect blend of fit, form and function.

Two things are at play with our intake systems, pressure and velocity. The flaring design of the Mega-Flo S-3 causes an increase in cross sectional area as the incoming air charge approaches the plenum area. The increased area slows the air velocity and increases the pressure. This is important because low velocity air has less drag as it encounters obstructions like the sharp turn into the plenum area. For example, the same thing happens at the entrance to the intercooler. The small pipe expands to the huge volume of the intercooler. This accomplishes two things. First it slows the air down so that all of the tiny intercooler passages don't cause unnecessary drag. Second it increases the pressure of the air so it can transfer heat more efficiently. For maximum airflow you need to look at the system as a whole.

The Mega-Flo S-3 was designed with a "perfect arc" in mind. Other designs include unnecessarily tight bends and flat walls. The Mega-Flo S-3 design eliminates the tight bends and flat walls found in other manifolds. Designs that require the air to make nearly a 90° turn against a flat face drastically reduce flow.

To lower restriction even further we have gone to a 5 bolt mounting design. This design eliminates the pass thru boss needed for the 6^th bolt and allows us to open the cross sectional area even further. Some 5 bolt manifold designs allow "gasket creep" which causes intake manifold gasket failure under boost. To eliminate this, we leave a gasket retainer boss for the 6^th bolt location during final machining. This boss captures the gasket and eliminates gasket creep due to thermal expansion cycles.

For accessories such as boost gauges, water/meth or nitrous the Mega-Flo S-3 is ready. On the back we have added five 1/8" NPT ports which will cover all of your additions with room to grow down the road.

For maximum cold air flow the new GDP Mega-Flo S-3 delivers!


All GDP Mega-Flo S-3 intake manifolds include mounting bolts, gaskets, plugs, and full color instruction manual.

Note: Only works with ATS twin CP-3 kits. Not for use with PPE or Industrial Injection's kits.