Cart is empty
Free Shipping on orders over $150! *Exclusions Apply
These come standard raw, if you would like it polished (shown in image) please select above.
Breather design is much nicer than most covers on the market, helps keep oil out of your blow-by tube.
May require SLIGHT trimming/grinding on the P7100 rear support bracket for proper fitment.
Also prevents that pesky tappet-cover gasket from blowing out, as you don't use one with this cover.
Please select your pump type. VP44 trucks do not have clearance to run a dual breather, so we include a plate to block the port towards the front.
Please note: On some trucks, grinding is required on the P7100 OR VP44 mounting bracket.
The stock cover is a crap design that is prone to fail and leak. It's also a pain to install without it leaking again.
This unit uses an o ring seal that seals perfectly and easily. 5/5
By Far the best Tappet Cover on the Market. The breather set up is Bad Ass!!!!