Shop By Category
Your Cart

03-07 Ford 6.0L Powerstroke Head Studs

Use Dieselsite 6.0L Head Studs on the following vehicles:
2003-2007 Ford F-Series Trucks with 6.0 Liter Powerstroke Diesel Engine
2004-2010 Ford E-Series Vans with 6.0 Liter Powerstroke Diesel Engine
2003-2005 Ford Excursion w/ 6.0 Liter 
Powerstroke Diesel Engine

20 Dieselsite Head Studs
20 Dieselsite12-point nuts
20 Dieselsite Hardened Washers
1   Container of Dieselsite Fastener Assembly Lubricant


    1. Inspect all hardware prior to installation. Look for defects or shipping damages, plus proper fit, length and dimension.
  • 2. To ensure proper thread engagement and accurate torque readings, clean ALL threads in the block. Chase if necessary with a Thread Chaser.
  • 3. Screw head studs into the block “HAND TIGHT ONLY” Use Allen key drive only to get stud past small restriction in the threads.

    Rated at 220,000 psi tensile strength

  • Following the manufacturers recommended torque sequence tighten the nuts in three equal steps to the following using Dieselsite Fastener Assembly Lubricant on studs, washers and nuts.

  • Studs A-J:

    • First step tighten to 75 ft-lbs. Second step tighten to 150 ft-lbs. Final Torque 220 ft-lbs.

  • Bolts k-o
  •          Tighten each bolt to 23 ft-lbs.  No sequence is needed after Head Studs have been torqued.

  • Part number: 60STUD

Lame California Prop 65 Notice